ESD Wrist Strap Ground includes a cord 15 feet long to ground into an electrical socket.
The coil cord for a wrist strap ends in a plug that can be connected to the yellow banana jack on the wrist strap ground. When a wrist strap is not being warn you can detach the cord snap from the wrist strap and attach it to the park on the wrist strap ground.
rist Straps can be grounded to a wrist strap ground that ties into an electrical socket
  • ESD Wrist Strap Ground includes a cord 15 feet long to ground into an electrical socket.
  • video-thumb-0
  • The coil cord for a wrist strap ends in a plug that can be connected to the yellow banana jack on the wrist strap ground. When a wrist strap is not being warn you can detach the cord snap from the wrist strap and attach it to the park on the wrist strap ground.
  • rist Straps can be grounded to a wrist strap ground that ties into an electrical socket
    • SKU: 4720 Category: Tags: , , , , ,

    20 in stock

    4720 Series grounds provide a ground for the wearers of wrist straps conveniently mounted underneath a workstation or bench.

    It has a 15 Foot Grounding Cable that ends in an eyelet to screw directly into a standard US Electrical Outlet.

    Prices

    Qty 1-9Qty 10-99Qty 100+
    $12.50 USD$11.57 USD$11.25 USD






    Specs

    DimensionSpecification
    Plug TypeTwo Receptacles for Banana Jacks
    Parking Snap4mm Stud
    Grounding Cable Length15 Feet
    Grounding Cable InsulationPolyurethane / PVC
    Grounding Cable Terminal Ends in #10 Ring to Screw into Electrical Outlet
    ResistorNo Resistor

    ESD Workstation Setup Video

    Transcript

    In this video, we are going to show you how to set up your 5300 series ANSI / ESD compliant workstation.

    First, roll out an ESD safe mat roll.

    This is the Elimstat 5300 series two-ply static dissipative mat. It is a two-ply nitrile rubber material that is 2 millimeters thick. The top surface is static dissipative and the bottom surface is conductive.

    Next, remove the 4715 common point ground from the bag. Snap the common point ground onto the installed 10 millimeter snap.

    Once the female snap on the mat is connected to the male snap on the common point ground, connect the eyelet on the other end of the wire to an outlet or to earth ground.

    To install the eyelet onto an outlet remove the outlet screw and attach the eyelet onto the outlet screw. Screw both back into the outlet, making sure both are secured tightly. This grounds the mat and any accessory plugged into the common point ground.

    Lastly, remove the wrist strap set from the bag and connect it to one of the two banana receptacles in the common point ground.

    Wrist straps directly capture static from your skin’s surface, protecting your ESD sensitive components.

    You may also like…