397 in stock


• Adjustable Stretch Velcro Strap tightens the fit onto the shoe.

• Lime Green makes it easy to identify being worn.


Qty 1-9Qty 10-99Qty 100+
$4.81 USD$4.20 USD$3.85 USD


Heel Cup Ground ContactSurface Resistivity is 104 to 106 Ohms
Heel Cup MaterialReinforced Black Carbon Loaded Rubber
Skin Ground ContactKnitted Ribbon with Silver Conductive Monofilament
attached to the Heel Cup is tucked into sock
Resistor1 Meg Ohm Resistor is Sewn into Silver Knitted Ribbon
Ankle AdjustmentVelcro Lime Green Strap
Charge Decay5000 volts to zero in less than 2 seconds

How Heel Grounders Work

Heel Grounders are a specific type of shoe grounder that use a conductive black carbon rubber heel to ground the shoe.

Materials like wood and wool are also insulating. Walking up and down a wool carpet with tennis shoes can easily cause us to hold static on our skin and clothes.

When we go to handle electronics we want to make sure we are not electrically isolated, but instead electrically bonded (also known as “being grounded”). This allows those static electrons to discharge from our clothes and skin to the ground beneath our feet. Wearing a heel grounder connected to an electrically bonded floor or floor mat is a common way to “ground” large assembly lines.

Diagram of How a Heel Grounder balances charge

When used with a grounded floor, anti static mat roll laid out as “floor runner”, or a workstation floor mat the shoe grounder dissipates static from you into the electrically bonded surface it makes contact with.

Diagram of Heel Grounder Construction

Connected to the tire-grade rubber heel is a conductive silver thread that tucks into your sock. The thread draws static electricity from your skin’s surface so that it grounds you and the shoe as one unit.

The way this works is that as the heel grounders make contact with electrically bonded surfaces (mats or floors) the electricity that was static on your shoes and skin is dissipated- literally falls into the Earth under the force of gravity.

1 Meg Ohm Resistors

1 Meg Ohm = 1 x 106 Ohms

How a 1 Meg Ohm Resistor works with the HGC-EV1 Heel Grounder

Made with a 1 Meg Ohm Resistor sewn into it, the silver knitted ribbon slows down an electrostatic discharge event (ESD) from a highly charged ungrounded surface from discharging instantaneously through the ribbon.

Typically a 1 Meg Ohm Resistor slows down an electrostatic discharge (ESD) a few more milliseconds than if it were not present.

You may also like…