Wrist Straps can be grounded at a common point with a mat or separately to a wrist strap ground that ties into an electrical socket
On the outside, the cord is made of polished polyurethane (PU) that is static dissipative.On the inside, the encapsulated 1 meg ohm resistor ensures that electrons are transferred through the cord to ground at a static dissipative rate.
SKU: N/A Category: Tags: , , , ,

• (1) Wristband captures static electrons directly from your body. Curved backplate.

• (1) Coil Cord (6 ft. or 12 ft.) carries static to ground. (1) Clip included: slides over cord plug if needed.

Prices

ProductQty 1-9 Qty 10-99Qty 100+
Anti Static Wristband Only$2.60 USD$2.36 USD$2.17 USD
Anti Static Wristband and 6′ Coil Cord$5.86 USD$5.33 USD$4.88 USD
Anti Static Wristband and 12′ Coil Cord$7.20 USD$6.55 USD$6.00 USD






Specs

DimensionQuality
FabricPolyester with Hypoallergenic Silver-Suffused Nylon
Thread Resistance100 ohms (typical) 160 ohms (maximum)
Ground Contact360 degrees around Wrist
ColorBlue
Wrist Strap Snap4mm Stud Snap
Snap Release1-5 lbs of Pressure
Wrist Strap Back Plate Curved Surgical Grade Stainless Steel
Cord Length6 foot and 12 foot options
Cord MaterialPolished Polyurethane Coil Insulation
Cord Snap Type4mm Socket Snap
Cord Plug TypeSwivel Type Plug with 6 leaves for Banana Jack
Cord Plug Alternative Alligator Clip slides over Plug for Banana Jack
Cord Resistor1 Meg Ohm Resistor Built Inside
Cord Diameter2.5mm
Cord Flex Life50,000 Flexes

Wrist Strap

Hypoallergenic silver-suffused nylon threading captures static directly from your skin’s surface at a conductive rate into a surgical grade stainless steel curved backplate.

ESD Resistance Chart for Elimstat Anti Static Wrist Straps

A 4mm stud snap on the wrist strap is where the 4mm socket snap of the coil cord connects to it.

For optimal performance, make sure nothing (including an ESD Smock sleeve) gets between the wrist strap and the skin surface of the wearer.

Coil Cord

On the outside, the cord is made of polished polyurethane (PU) that is static dissipative.

1 Meg Ohm Resistor built into Cord for Wrist Strap for Static Dissipative Transfer Rate to Ground / Earth

On the inside, the encapsulated 1 meg ohm resistor ensures that electrons are transferred through the cord to ground at a static dissipative rate.

Static electrons collected off your body by the wrist strap are transferred to ground by attaching the coil cord to grounding:

a wrist strap ground, or a common point ground.

Alternatively, you can clip the coil cord to a metal railing with the included alligator clip (which slides over the plug).

1 Meg Ohm Resistor

1 Meg Ohm = 1 x 106 Ohms

1 Meg Ohm Resistor built into Cord for Wrist Strap for Static Dissipative Transfer Rate to Ground / Earth

A 1 Meg Ohm Resistor is built into the coil cord to slow down an electrostatic discharge event (ESD) from a highly charged ungrounded surface from discharging instantaneously through the coil cord.

Typically a 1 Meg Ohm Resistor slows down an electrostatic discharge (ESD) a few more milliseconds than if it were not present.

You may also like…